Spinner RoCket with folding propeller 14×8 – red
Spinner RoCket with folding propeller 14x8 - red
Item No. 67108064
Spinner RoCket with folding propeller 14×8 red
The new spinner and folding propeller unit completes the overall picture of the RoCket.
This is a pre-assembled system consisting of: plastic spinner with high-quality 2-component paintwork, special folding propeller, aluminum driver optionally with a 5, 6 or 8 mm hole, a GRP spacer and a repositioning elastic band. The unit was constructed in such a way that in the event of a rough landing or a crash, the propeller is unlikely to break as long as the engine is stationary during touchdown.
Special folding propeller
The aerodynamic efficiency and the resulting low-noise operation are particularly noteworthy. Furthermore, there is an extraordinary response behavior when switching on the engine and the immediate acceleration of the model due to the direct flow on the propeller profile. This saves many a botched start, especially with “zero wind starts”, since the thrust, compared to other propellers, is available faster than the model has ground contact.
- Spinner diameter approx. 55mm
- 14×8 propeller
- For shaft diameters 5, 6 or 8mm
plastic spinner with high-quality 2-component paintwork, special folding propeller, aluminum driver optionally with a 5, 6 or 8 mm hole, a GRP spacer and a repositioning elastic band.
The fully assembled unit consists of: spinner, 14×8 folding propeller, aluminum mount, a GRP spacer, and repositioning elastic band (made of rubber) greased with Vaseline
(The set does not include the RoCket harness)
New in our shop
Whether you require specific information about a certain product, or have a motor that needs inspection or repair, visit our motor service page.
Hacker Motor Wiki
In the Hacker Motor Wiki you will find operating instructions, technical data, and other important information about our products.