JETImodel Enlink 2RS Plus – DUO

EnLink 2RS plus (set contents: 2 pieces)

The Enlink 2RS Plus is a component for increasing safety through redundancy. This allows, for example, two receiver outputs (from 2 separate receiving systems) to be switched to one servo. If one receiving system fails, the Enlink 2RS Plus switches to the second receiving system and the servo continues to run without interference.

The Enlink 2RS Plus can also be used with a special firmware for using an EX Bus, UDI or PPM signal. For example, two RSAT2s can be connected to an FBL or stabilization system as redundant receivers. Especially in conjunction with the two RF modules in a JETI Duplex DC-16 or DS-14/16 transmitter in “two-way RF mode”, this is a real safety gain thanks to the double radio link. For example, the RSAT 900Mhz (when used with the DC/DS-24 transmitters) can be connected to a CentralBox 200 (or others) as a third receiver. You can find the instructions here under the “Downloads” tab.

It can also be used as a pulse amplifier for the EX Bus, UDI or PPM signal with long connection cables between, for example, the main receiver/CentralBox and RSAT 2. The connection is then unidirectional, i.e. data is only transmitted in one direction.

Technical data:
Weight [g]: 11
Dimensions [mm]: 38 x 12 x 6.5
Continuous current [A]: 3
Operating temperature [°C]: -20 … 85
Recommended input voltage [V]: 5 .. 8.4
Input voltage max. [V]: 16
Peak current (max 5s) [A]: 12